User manual

e Electro Industries/GaugeTech Doc # E113-7-07 V1.04 1-11
1.6: Connecting the Substation Multiplexor Directly to a Computer
1. Use an RS232 cable to connect the Substation Multiplexor’s Master Port to an available RS232 port
on the computer.
2. Set the 232(DCE)Network switch beneath the Master Port to 232(DCE).
3. The Master Port is factory-set to operate at 57600 baud. To configure and communicate with the
Substation Multiplexor, run a standard terminal program on the computer, such as Windows
HyperTerminal. See Chapter 3 for details.
1.7: Connecting to the Substation Multiplexor Using the Ethernet.
1. Connect an RJ-45 cable to the Substation Multiplexor’s RJ-45 jack.
2. Set the 232(DCE) Network switch beneath the Master Port to Network.
3. Use a standard terminal program on the computer, such as Windows
®
HyperTerminal, to connect to
the Substation Multiplexor and configure it. See Chapter 3 for details.
4. The Ethernet Port is factory-set to operate at 57600 baud. You should keep the port set to 57600 after
you have connected.