User manual

eElectro Industries/GaugeTech Doc # E113-7-03-1.18 2-16

2.12: Go to Throughput Mode2.12: Go to Throughput Mode

The GT command puts the Substation Multiplexor in Throughput Mode, allowing the computer to

communicate with the device(s) connected to the selected Multiplexor Slave Port. The Substation

Multiplexor will not accept commands in Throughput Mode. To return to Command Mode send the

escape string detailed in section 2.5.

• Type GT[Enter]

2.13: Go to Boot Mode2.13: Go to Boot Mode

Boot Mode is used for flash upgrading ONLY, as additional features become available. This feature

is reserved for use by EIG technicians, unless you are otherwise authorized.

• Type GB[Enter].

2.14: Go to Mode Selection2.14: Go to Mode Selection

In previous versions, Substation Multiplexor always started in Command Mode. Now, you can

choose Command or Throughput Mode. The advantage of this new feature: When SM1-16 resets

for any reason, it will be in your mode of choice.

• Type GMC[Enter]for Command Mode.

• Type GMT[Enter]for Throughput Mode.

• To confirm this change, Type HU[Enter] (the Unit Status command; see section 2.9).

2.15: Password Protection2.15: Password Protection

Password Protection is available for Command Mode and Throughput Mode. Each mode is

protected by its own password and each password is independent from the other.

• Type PW[Enter]. The following screen appears:

------------------------------------------------------

PASSWORD PROTECTION

COMMAND MODE : DISABLED

THROUGHPUT MODE : DISABLED

PASSWORD COMMANDS

PWCE : Enable Password for Command Mode

PWCD : Disable Password for Command Mode

PWTE : Enable Password for Throughput Mode

PWTD : Disable Password for Throughput Mode

------------------------------------------------------