User manual

eElectro Industries/GaugeTech Doc # E113-7-03-1.18 2-14

2.9: Unit Status2.9: Unit Status

Use this command to view a list of all Substation Multiplexor settings.

• Type HU[Enter]. The following screen appears.

------------------------------------------------------

SUBSTATION MULTIPLEXOR

BOOT VERSION : V1.6

SOFTWARE VERSION : V3.6

CURRENT CONNECTION : PORT 15

START-UP CONNECTION : PORT 15

START-UP MODE : COMMAND MODE

ESCAPE SEQUENCE : %%%

MODEM TYPE : INTERNAL

MODEM BAUD RATE : 9600

RING NUMBER : 2

SITE ID : 44

MODEM STRING : NA

RESET TIME : 10 MINUTE

HANG-UP TIME : 10 MINUTE

MODEM DETECT RELAY : DISABLED

------------------------------------------------------

In the previous runtime version (v35), all commands were available when the unit was in command

mode. There are two types of commands; one type can change the programmable settings in the

Flash, the other type cannot change the settings in Flash.

In this runtime version (v36), after Powerup or Reset, the commands that change the data in

the Flash will be disabled.

For example, if you type PS03[Enter], the unit will respond ‘Type H[Enter] to enable this command’.

• To Enable these commands, enter the H cammand first. Send H[Enter]. Then send

PS09[Enter].OK will appear on your screen to confirm that the command is enabled.

• To Disable these commands, enter the HU command. The HU command will disable all

commands that can change the data in Flash.