User manual

eElectro Industries/GaugeTech Doc # E113-7-03-1.18 2-5
• Click on the Modify button; click on the Settings tab. The following screen appears.
7. In the “Emulation” field, select ANSI from the pull-down menu.
8. Click on the ASCII Setup button. In the “ASCII Sending” section, click both boxes. In the “ASCII
Receiving” section click all boxes except the “Force incoming data to 7-bit ASCII”. The ASCII
Setup screen should look like the following:
9. Click OK. You are now ready to dial the Substation Multiplexor. Proceed to section 2.5.