User manual

eElectro Industries/GaugeTech Doc # E113-7-03-1.18 2-4
5. Make a selection from the “Connect Using” menu. Different screens will appear, depending on your
selection. All of the screens will take you to the Multiplexor Properties and ASCII Setup screens:
To make a modem connection:
Enter the Country code, Area Code and Phone Number. In the “Connect using” field, select the type
of modem connected to your computer. Proceed to step 6.
To make a direct connection to the Substation Multiplexor’s Master Port from the computer:
Select Direct to Comx from the “Connect using” pull-down menu, where x is the computer’s com
port. Click OK. The Comx Properties screen appears:
Select 9600 from the Bits per Second pull-down menu. (The Substation Multiplexor's Master Port is
factory-set to 9600 baud.) Click the Advanced... button to set Receive and Transmit Buffers. Click
OK.
Select Properties from the File Menu on your main screen and click the Settings tab. Skip to step 7.
6. Click OK. The following screen appears.