User Manual

13
PRESET SAVE PROCEDURE:
1. To Save the knob positions that are currently set up, press and
hold down the MODE knob.
2. Hold down MODE for 3 seconds. Nothing will occur for 2
seconds, then all the mode LEDs will blink for 1 second.
3. After the LEDs stop blinking, let go of the MODE knob. The
PRESET LED will light up solid. The PRESET LED is located to the
left of the PRESET FOOTSWITCH.
4. Your preset has been saved in the mode that is currently lit.
PRESET LOAD PROCEDURE:
USING MODE KNOB
1. To Load a preset you previously saved: turn the MODE knob to
the mode where the preset was saved.
2. Press and release the MODE knob. The PRESET LED will light up
to indicate that the Preset has loaded. Please Note: The current
knob positions are no longer valid.
USING PRESET FOOTSWITCH
To Load a preset you previously saved using the PRESET Footswitch:
press and release the PRESET Footswitch. The PRESET LED will light up
to indicate that the Preset has loaded for the currently selected mode.
Please Note: The current knob positions are no longer valid.
If you press and release the PRESET Footswitch while a preset is already
loaded into the current mode, the Voice Box will jump down to the next
mode and load its preset. For example, if you have a preset loaded into
HIGH HARMONY mode, then press the PRESET Footswitch, the Voice
Box will then select LOW + HIGH as its current mode, then load its
preset.
14
After loading a preset, if you move a knob, the knob’s new location will
supersede the preset’s stored value for that knob. At this point, the
PRESET LED will blink rapidly to indicate that a knob has been moved. If
you then turn the knob back to its position, as saved in the preset, the
PRESET LED will stop blinking.
If the PRESET LED is blinking rapidly, when you press the PRESET
Footswitch, it will re-load the preset for whichever mode you are
currently in.
PRESET UNLOAD PROCEDURE:
A preset can be unloaded to restore the current knob positions so they
represent what you hear. There are two ways to unload a preset, press
and release the MODE knob or turn the MODE knob to another mode.
- CONTROLS, INDICATORS & I/O-
The following descriptions detail all of the knobs, switches, LEDs (lights)
and I/O jacks on the Voice Box:
MODE KNOB
This is the white knob located in the upper right corner of your Voice
Box. The MODE knob is a rotary encoder enabling the user to scroll
through the 9 Modes of the Voice Box. Turn the knob clockwise to
progress up through the modes: from VOCODER to LOW HARMONY
mode. Turn the knob counter-clockwise to progress down through the
modes: from LOW HARMONY to VOCODER mode.
The MODE knob also has a push switch to save and load presets. To
load a preset: turn the MODE knob to select the desired mode and then
give the MODE knob a quick tap. To save a preset: push down and hold
the MODE knob for 3 seconds. You will then see all mode LEDs blink
rapidly. Continue to hold down the MODE knob until the LEDs stop
blinking. At this point the preset is saved and you can let go of the knob.
Only one preset is saved per mode and the preset you save is based on
the selected mode.