Manual

9
- PRESETS -
The V256 can save one preset for each of the 9 modes. Each preset will pertain directly to the
mode you have saved it in. Once a preset is saved, the V256 will remember the preset after
power has been disconnected.
Saving a preset will save the setting of all 5 of the black knobs. The V256 will also save any
frozen samples that are created by holding the MIC BYPASS footswitch. You must hold down
the MIC BYPASS footswitch while saving the preset to save the frozen sound.
The V256 will not save the state of the MIC BYPASS footswitch, the MIC GAIN toggle switch
or the PHANTOM POWER toggle switch.
PRESET SAVE PROCEDURE:
1. To save the knob positions as they are currently set, press and hold down the MODE
knob.
2. Hold down the MODE knob for 3 seconds. Nothing will occur for 2 seconds, then all the
mode LEDs will blink for 1 second.
3. After the LEDs stop blinking, release the MODE knob. The PRESET LED will light up solid.
The PRESET LED is located to the left of the PRESET footswitch.
4. Your preset has been saved in the mode that is currently lit.
PRESET LOAD PROCEDURE:
USING THE MODE KNOB
1. To Load a preset you previously saved: turn the MODE knob to the mode where the
preset was saved.
2. Press and release the MODE knob. The PRESET LED will light up to indicate that the
preset has loaded. Please Note: The current knob positions are no longer valid.
USING THE PRESET FOOTSWITCH
1. To Load a preset you previously saved using the PRESET footswitch: press and release
the PRESET footswitch. The PRESET LED will light up to indicate that the preset has
loaded for the currently selected mode. Please Note: The current knob positions are no
longer valid.
2. If you press and release the PRESET Footswitch while a preset is already loaded into the
current mode, the V256 will jump down to the next mode and load its preset. For
example, if you have a preset loaded into VOX-ROBO 1 mode and press the PRESET
footswitch, the V256 will then select VOX-ROBO 2 as its current mode, with its preset
loaded.