Manual
14
INST INPUT ¼” Jack
In the vocoder modes of the V256, the instrument signal can be used as the carrier signal for
the vocoder effect. In INSTRUMENT CTRL mode, the instrument signal is used to determine
the note that will replace the pitch of the sung note. In REFLEX-TUNE mode, with the PITCH
knob set fully CCW, the instrument signal will determine the diatonic key and the V256 will
quantize to notes in that key scale. In TRANSPOSITION mode, the instrument input has no
function.
Plug the output of your instrument into the INST INPUT jack. The input impedance presented
at the INST INPUT jack is 2.2 M
.
EFFECT OUTPUT XLR Jack
The V256’s effect is output through the EFFECT OUTPUT XLR jack on the side of the unit. The
effect signal as well as the dry and bypassed vocals are output from this jack. The EFFECT
OUTPUT XLR jack is a fully balanced line output jack. It can be connected directly to the line
input of a mixer, on stage breakout boxes or the input of an A/D converter. The output
impedance is 700
.
INST OUTPUT ¼” Jack
The Instrument output on the V256 outputs a blend of the effected signal as well as the dry
instrument signal or MIDI controlled internal synthesizer. The mix is set from the factory
100% dry and initially only instrument signal will be output from this jack. To change the
output mix on this jack, hold down the MIC BYPASS footswitch and turn the BLEND knob.
When the BLEND knob is fully CCW, it will output 100% instrument signal. At noon, the
output will be an even mix of V256 effect and instrument signal. At fully CW, the output will
be 100% effect signal.
Connect this output to your amp, effect pedals or other devices. The output impedance is 700
.
9V Power Jack
Plug the output of the V256’s supplied AC Adapter into the 9V power jack located at the top
of the V256. The V256 requires 9 to 9.6VDC at 200mA with a center negative plug. The V256
accepts Boss style AC Adapters.