User Manual

Switching on one channel automatically switches off the other two. This
useful to use the Tri Parallel Mixer as more of a switcher and less of a
mixer.
To switch between these modes:
1) Hold the CH 1 and CH 2, or the CH 2 and CH 3 footswitch
together, for about a second, until the three upper LEDs are
blinking.
2) The LEDs will either be blinking in unison, indicating AND Mode,
or blinking one after another, indicating XOR Mode.
3) To change the setting, simply press and release any of the three
footswitches.
4) Once you have set it to your desired setting, hold down any one
of the three footswitches for about a second, until the LEDs stop
blinking.
FACTORY RESET
Upon powering up, the Tri Parallel Mixer will remember your last
settings, as far as which channels were active and the current Muting
Mode and AND/XOR Mode. To easily reset everything to the default
settings, perform a factory reset by following these steps:
1) Unplug the 9V power from the Tri Parallel Mixer
2) Hold down the CH 1 and CH 3 footswitches
3) While still holding them down, plug in the 9V power
4) All four LEDs will light for about a half second, then the top
three LEDs will go off. The Factory Reset is complete.
-PARALLEL EFFECT MIXING-
In a traditional setup with multiple effects pedals, effects are run in
series, with the output of one connected to the input of the next. In this
configuration the sound created by an effect earlier in the chain will
greatly affect any effects used later in the chain. The Tri Parallel Mixer
allows you to use effects in parallel, where each effect acts on your input
signal independently, and is then combined. This allows for tonal
options not possible when running effects in series. A couple of
examples are shown and explained below: