User Manual

Using an External Oscillator -

To use an external oscillator to modulate pitch

shift, turn the WAVE knob to full counter-clockwise and plug the external oscillator

into the MOD input. The FINE/DEPTH knob controls the depth of the external

modulation. Note: turning FILTER/RATE to full counter-clockwise will disable external

modulation.

Using an Expression Pedal –

Plug an expression pedal into the EXP ¼” Jack to

control the Pitch Shift amount. The expression pedal’s pitch shift range is set by the

COARSE knob. The toe down position will be the current setting of the COARSE knob,

the toe up position is no pitch shift, though you will still hear the pitch shift’s

modulation.

Troubleshooting –

Not hearing the Pitch Shift or just something unexpected?

Check to make sure that the BLEND knob is 50% or higher. If the modulation is

making it hard for you to hear what is going on, turn modulation off by turning the

FILTER/RATE knob down to full counter-clockwise and then set FINE to 12 o’clock.

SUGGESTED SETTINGS

–

Below are some suggested settings for getting started with

the Ring Thing.

DETUNE

RING MOD

RING VIBE