User Manual

CONFIGURATIONS (cont.)
TWO AMPLIFIERS
Utilizing just the SEND jacks of the Switchblade Pro will allow you to split your signal between
two amps. Use the A/B footswitch to switch between SEND A and SEND B. The
SERIES/PARALLEL toggle switch only needs to be set to PARALLEL if you want to use both
outputs at the same time (A+B).
Note: To avoid hum, the ground connection on one of the amplifiers may need to
be lifted. Either use the ground lift feature on the amplifier or use a 3-prong-to-
2-prong power adapter (aka “cheater plug” or “AC ground lifter”).
CONFIGURATIONS (cont.)
THREE INSTRUMENTS TO ONE AMPLIFIER
A multi-instrumentalist can use the Switchblade Pro to connect up to three instruments to a
single amplifier. To engage the guitar in the example below, put the Switchblade Pro into
bypass. Engaging the Switchblade Pro allows you to switch between either the electric violin
or the keyboard and the volume of each instrument is controlled by the A and B LEVEL knobs.