User Manual

5
WAVE is set to RHYTHM, the SHAPE knob acts like a switch as you rotate it:
allowing you to choose between 1 of 9 available rhythms. The following table
indicates waveshapes available near the extremes and in the middle of the
SHAPE knob’s rotation. See the TIPS AND TRICKS section on page 14 of this
manual for creating your own Rhythm patterns.
WAVEFORM
SHAPE CCW
SHAPE Middle
SHAPE CW
SINE
Peak Sine:
Normal Sine:
Flattened Sine:
TRIANGLE
Ramp Up:
Triangle:
Ramp Down:
PULSE
4% PulseWidth:
50% Pulse Width:
100% Pulse Width
RHYTHM
Pattern 1
Pattern 5
Pattern 9
RT. PHASE Knob – RT. PHASE turns the Super Pulsar’s stereo tremolo into a
panning effect. Please note: you will only hear the effects of the RT. PHASE knob
when you have the Stereo Pulsar set up in some sort of stereo configuration
whether it’s mono in/stereo out, stereo in/mono out or stereo in/out. The RT.
PHASE knob is inactive in the mono in/out setup.
MONO IN / STEREO OUT Setup: The RT. PHASE knob adjusts
the phase of the Right channel’s modulation waveform in relation
to the Left channel’s waveform. At 0°, the Right and Left Channel
modulation waveforms are in phase with each other. As you turn
RT. PHASE up from 0° the Right channel will lag behind the Left
channel all the way to 360° (which is really the same as 0°). For
typical sine wave modulation, a RT. PHASE setting of 180° will yield
maximum loudness in the Right channel when the Left channel is at
its quietest.
STEREO IN / MONO OUT or STEREO OUT Setup: The RT.
PHASE knob adjusts the amount of the Right input that is output
from Left output and the amount of Left input that is output from
the Right output. At 0° the Right input comes out the Right output
only and Left input comes out Left output only. Set RT. PHASE to
180° and you will hear an equal mix of Left input at the Right
output and Right input at the Left output. Turning the knob all the
way up to 360° will reverse the input/output channels completely
so that the Right channel is only output from the Left output and
Left channel is only output from the Right output. The modulation
waveforms are normally in phase with each other but if you enable
the WAVE INVERT button, the right channel’s modulation waveform
will be inverted as compared to the left channel. When DEPTH = 0,
turning RT. PHASE, or sweeping with an Exp. Pedal, will allow the
two inputs to cross-fade between the two outputs.