User Manual

13
TAP SETTING ( tAP ):
• When tAP is set to ON , the Super Switcher automatically outputs
tempo signals via the TAP output jack based on preset BPM or
received MIDI clock. When tAP is set to OFF , the TAP output only
sends signals that mirror presses of the TAP footswitch.
• Press and release VALUE to set the status of the TAP output. Turn
VALUE to select ON or OFF .
• ON sets the TAP output to automatic; four tap signals will be sent
out every time the BPM is updated. OFF will set the TAP output to
work like a manual tap tempo footswitch.
• Press and release VALUE to go back. Turn VALUE to show Ct1 .
CONTROL 1 SETTING ( Ct1 ):
• The Ct1 setting controls the function of the CTRL 1 footswitch.
• Press and release VALUE, the character display will show NO . Turn
VALUE to select NO or NC . This is the switch behavior “normally
open” or “normally closed”. Normally open is most common. Press
and release VALUE again to show LAt .
• Turn VALUE to select between LAt for latching, NON for
momentary and bP for master bypass.
• Press and release VALUE to go back. Turn VALUE to show Ct2 .
CONTROL 2 SETTING ( Ct2 ):
• The Ct2 setting controls the function of the CTRL 2 footswitch.
• Press and release VALUE and the character display will show NO .
Turn the encoder knob to select NO or NC . This is the switch
behavior “normally open” or “normally closed”. Normally open is
most common. Press and release VALUE again to show LAt .
• Turn VALUE to select between LAt for latching and NON for
momentary.
• Press and release VALUE to go back. Turn VALUE to show ChL .
MIDI RECEIVE CHANNEL SETTING ( ChL ):
• The ChL setting controls the channel on which the Super Switcher
receives MIDI messages.
• Press and release VALUE and the character display will show 1 .
Turn VALUE to select the MIDI receive channel between 1 - 16 or
ONI for omni.
• Press and release VALUE to go back. Turn VALUE to show CLC .