User Manual

respond quickly to your playing. When set to SLOW the envelope follower will
respond slowly to your playing.
In LFO mode the toggle switch determines the shape of oscillation. In the UP
position the LFO will produce a triangle wave, giving the phase shifter a smooth
modulation from the START to STOP settings. In the DOWN position the LFO will
produce a square wave oscillation and the phase will jump between the START and
the STOP settings.
EXPRESSION PEDAL/EXP MODE – In EXP mode the phase shifter circuit is controlled
by an expression pedal or control voltage. In this mode, the GAIN and RATE knobs
are inactive. The START and STOP knobs will determine the range of modulation.
The ‘toe-up’ position of the expression pedal corresponds to the setting of the START
knob. The ‘toe-down’ position corresponds to the setting of the STOP knob. As you
move the expression pedal from ‘toe-up’ to ‘toe-down’ the phase shifter will move
from the START to STOP settings.
The expression pedal may also be used in ENV mode and in LFO mode. Use the
START and STOP knobs to determine the RANGE of modulation. When the expression
pedal is ‘toe-up’ the envelope and LFO will modulate over the full range set by the
START and STOP knobs. As you move the expression pedal to ‘toe-down’ the ENV
and LFO RANGE will decrease towards the point set by the STOP knob.
FOOTSWITCH/STATUS LED – The footswitch engages/disengages the effect. If the
effect is engaged, the LED will light up. In true-bypass mode, the LED is off.
INPUT Jack – Connect your instrument’s output to this ¼” mono jack. The input
impedance presented at this jack is 380 kohms.
MAIN OUT Jack – Connect this ¼” mono jack to your amplifier’s input. The output
impedance presented at this jack is 250 ohms. When using the Stereo Polyphase as a
mono device we recommend you use the MAIN OUT jack.
STEREO OUT Jack – Connect this ¼” mono jack to your second amplifier’s input. The
output impedance presented at this jack is 250 ohm. When using the Stereo
Polyphase as a stereo device use the STEREO OUT jack for your second channel.
EXP. PEDAL Jack – Connect this ¼” stereo jack to your expression pedal. The
expression pedal must have a connection for a TRS cable, stereo ¼”. You cannot use
a volume pedal. We recommend the following expression pedals: M-Audio EX-P,
Moog Expression Pedal, and Roland EV-5. You may also connect a Control Voltage,
from a synthesizer for example, to the Exp. Pedal Jack. The Control Voltage must be
between 0V~5V.