User Manual
CONTROLS AND CONNECTIONS
SHIFT Knob Rotary Switch The 11-position SHIFT switch selects the maximum
bend setting or the interval of chromatic transposition. The table below details the
pitch effect relative to the original pitch.
D
m2
M2
m3
M3
P4
P5
M6
1
2
3
Det-
une
Minor
2nd
Major
2nd
Minor
3rd
Major
3rd
Perfect
4th
Perfect
5th
Major
6th
1
Oct
2
Oct
3
Oct
Note: “Detune” uses a slight interval to create a detune effect that is close to a chorus or doubling effect.
DIR (direction) Toggle Switch The DIR switch selects whether pitch is shifted
up (), down (), or both simultaneously (DUAL).
The DUAL setting outputs two pitch-shifted signals. The first transposed signal
follows the SHIFT knob as if in UP mode. The second transposed signal depends
on whether the PEDAL switch is set to PITCH or X-Fade:
1. When PEDAL is set to PITCH mode, the secondary shifted signal bends
at the same rate as the primary signal—usually in the opposite direction,
but not always. The secondary signal maxes out at a musically useful
harmony that varies by the interval set with the SHIFT knob. This table
lists the DUAL mode SHIFT knob settings with PEDAL set to PITCH mode:
D
m2
M2
m3
M3
P4
P5
M6
1
2
3
Det-
une
m2
up
+
Detune
down
M2
up
+
M6
up
m3
up
+
P5
up
M3
up
+
P5
up
P4
up
+
P5
down
P5
up
+
1 Oct
down
M6
up
+
P5
down
1 Oct
up
+
1 Oct
down
2 Oct
up
+
1 Oct
down
3 Oct
up
+
1 Oct
down
2. When PEDAL is set to X-FADE, the secondary shifted signal is set by
the PITCH MIX knob and does not bend. The volume of the secondary
signal decreases by sweeping the pedal from heel to toe.
Flip the PEDAL switch to choose the function of the foot pedal: select either PITCH
or X-FADE mode.
In PITCH mode: the foot pedal bends the pitch of your notes. The toe position
yields maximum pitch bend, while the heel position’s pitch bend is set by the PITCH
MIX knob.
In X-FADE mode: the foot pedal crossfades from your dry signal to the transposed
signal at an interval set by the SHIFT knob. The cross-fade effect will vary
depending on the DIR toggle switch setting:
DIR UP () or DOWN (): the dry signal is in the heel, and the pitch
shift effect is in the toe.
DIR DUAL: the heel pitch is set by PITCH MIX knob (ranging from -1
Octave to +1 Octave), and the toe’s upward pitch is set by SHIFT knob.