User manual

– PRESETS –

Press and release the PRESET footswitch once to enter PRESET MODE. The Ravish

has ten fully programmable presets. Saving a preset will capture the setting of each

of the five black knobs and all internal settings. Once a preset is saved, the Ravish

will remember its settings after power has been disconnected. Preset ten is denoted

by the Roman numeral “X”. The Ravish also has What You See Is What You Get

(WYSIWYG) mode, denoted by a “W” on the preset display.

Preset Save Procedure

1. Once you have created a sound you want to save or if you want to save an

edited preset, turn the MODE/PRESET knob to display the preset LED

number where you want to save the setting to.

2. Press down and hold the MODE/PRESET knob for 3 seconds. The preset

digit will blink to indicate save completion.

3. After the digit stops blinking, release the MODE/PRESET knob. The PRESET

LED will light up solid.

4. Your preset is now saved.

Preset Load Procedure

There are two options for loading presets:

A. Press and release the PRESET footswitch repeatedly until the preset you

want to load is selected. Make sure the PRESET LED is lit to indicate your

preset is loaded. Please Note: The current knob positions are no longer

valid.

B. Use the MODE/PRESETS knob and the PRESET footswitch.

1. Turn the PRESETS knob so the preset number where the preset was

saved is selected.

2. Press and release the PRESET footswitch. The PRESET LED will light up

to indicate that the preset is loaded. Please Note: The current knob

positions are no longer valid.

After loading a preset, if you move a knob, the knob’s new location will supersede

the preset’s stored value for that knob. At this point, the PRESET LED will blink

rapidly to indicate that a knob has been moved, though a preset is still loaded.

Preset Unload Procedure

A preset can be unloaded to restore the current knob positions. Turn the

MODE/PRESETS knob clockwise until a “W” appears on the preset display. Once the

“W” appears, the preset is unloaded and the current knob positions take over. This

will also revert the KEY, DECAY, MODULATION and PITCH BEND parameters to their

prior, non-preset settings. If preset X is loaded, upon pressing the PRESET

footswitch, the Ravish will cycle to WYSIWYG mode, where no preset is loaded.

Press the PRESET footswitch again and preset 1 will load.

Factory Preset Restore Procedure

1. Press and hold down the MODE/PRESET knob and the PRESET footswitch

while applying power.

2. After applying power, continue to hold down both switches until you see all

of the LEDs blink rapidly. At this point you can release the switches; the

factory presets have been restored.