User manual

4
– SWITCH FUNCTIONS –
MODE/PRESET Encoder – This white knob has three functions:
1. When in preset mode turn this knob to scroll through the presets, though it
will not load the preset. To load the selected preset, press and release the
PRESET footswitch.*
2. Press and hold the PRESET knob for 3 seconds to save a preset.*
3. Press and release the PRESET knob (without holding it down) to toggle
through the PRESET, KEY, DECAY, MODULATION, PITCH BEND and Q
modes.**
*See the PRESETS section for more on presets.
**See page 7 for more information.
BYPASS Footswitch & LED – Pressing the BYPASS footswitch will toggle the
Ravish between Effect mode and buffered Bypass mode. The associated red LED,
near the BYPASS Footswitch, will light to indicate Effect mode. When this LED is off,
the Ravish is in Bypass mode.
PRESET Footswitch & LED – The PRESET footswitch serves three purposes:
1. Press and release the PRESET footswitch to load a selected preset. If a
preset is already loaded, the Ravish will increment up to the next preset in
a cyclical fashion. The PRESET LED will light up solid, indicating a preset is
loaded.*
2. When in KEY MODE, press and hold the PRESET footswitch to engage the
custom tuning feature of the Ravish.**
3. When in any mode other than KEY MODE, press and hold the PRESET
footswitch to freeze the sympathetic strings.***
*See the PRESETS section for more on presets.
**See the KEY MODE section for more on key mode.
***See the FREEZE MODE section for more on freezing the sympathetic strings.