User Manual

9V Power Jack - Plug the output of the supplied AC Adapter into the 9V power jack located at the top of
the
POG2 . The POG2 requires 180 mA at 9 VDC with a center negative plug. The POG2 accepts Boss style
AC Adapters.
- PRESETS -
The
POG2 can save and load up to 8 presets. The position of all sliders and the setting of the two push-
buttons are saved with each preset. The state of the BYPASS FSW is not saved with the presets. The
POG2
will remember all presets after power down has been removed.
PRESET SAVE PROCEDURE:
1. To save the current slider positions and push-button settings, press and hold down the white
PRESET knob.
2. Hold down the PRESET knob for 3 seconds. Nothing will occur for 2 seconds, then all the preset
LEDs will blink for 1 second.
3. After the LEDs stop blinking, release the PRESET knob. The PRESET LED, located to the right
of the PRESET Footswitch, will light up solid.
4. Your preset has been saved in the preset number that is currently lit.
PRESET LOAD PROCEDURE:
USING PRESET KNOB
1. To Load a preset you previously saved: turn the PRESET knob to the preset number where the
preset was saved.
2. Press and release the PRESET knob. The PRESET LED, near the PRESET Footswitch, will light
up to indicate that the Preset has loaded. Please Note: The current slider positions are no
longer valid.
USING PRESET FOOTSWITCH
1. To Load a preset you previously saved using the PRESET Footswitch: press and release the
PRESET Footswitch. The PRESET LED will light up to indicate that the Preset has loaded for the
currently selected preset number. Please Note: The current slider positions are no longer valid.
2. If you press and release the PRESET Footswitch while a preset is already loaded, the POG 2 will
jump down to the next preset and load the preset. For example, if you currently have Preset 3
loaded, pressing the PRESET Footswitch will select and load Preset 4.
After loading a preset, if you move a slider or press a push-button, the control’s new location or setting will
supersede the preset’s stored value for that control. At this point, the PRESET LED, near the PRESET
Footswitch, will blink rapidly to indicate that a control has been moved or changed. If you then return the
control back to its original position, as saved in the preset, the PRESET LED will stop blinking.
If the PRESET LED is blinking rapidly, when you press the PRESET Footswitch, it will re-load the current
selected preset.
PRESET UNLOAD PROCEDURE:
A preset can be unloaded to restore the current knob positions so they represent what you hear. There are
two ways to unload a preset: press and release the PRESET knob or turn the PRESET knob to select a
different preset number.