User Manual

37
SAVING ALTERED PRESETS
If you would like to save an altered preset to the current Reverb Type,
press and hold the REVERB TYPE knob for about 2.5 seconds. Release
once the PRESET LED stops blinking and is lit solid. Note: altered
Expression Settings are automatically saved to presets. See below.
UNLOADING PRESETS
To unload a preset and return to What You See Is What You Get mode
(WYSIWYG):
1. Ensure the PRESET LED is lit solid
2. Press and release the REVERB TYPE knob.
3. The PRESET LED shuts off and you are in WYSIWYG mode.
SAVING EXPRESSION PEDAL SETTINGS TO PRESETS
If the EXP MODE button is on when a preset is saved, the current
Expression Setting will be saved to that Reverb Type’s preset. The EXP
MODE button will be saved in the on state.
If a new custom Expression Setting is created while a preset has been
loaded (the PRESET LED is lit), the new setting will be automatically saved
to the preset. The PRESET LED will blink at the end of the Expression
Setting creation procedure to indicate that the new setting has been saved
to the preset. Note: if an expression pedal setting is created and saved
while the preset is loaded, any other unsaved control alterations will be
lost. Make sure to save any desired knob alterations to the preset before
updating the preset's Expression Setting.