User Manual

36
PRESET USE AND SETUP
The Oceans 12 can save and recall one preset per Reverb Type for both
Reverb A and Reverb B. Each preset saves all current knob settings
(including all alternate FUNCTION knobs, except DUAL and FX LOOP
parameters), the current expression settings, tap tempo if in Echo reverb,
the mode button status, and all illuminated button settings (except
FUNCTION).
SAVING PRESETS TO A REVERB TYPE
1. Use the SELECT button to select the reverb engine for which you’d
like to save a preset.
2. Turn the REVERB TYPE knob to the specific Reverb Type that you
want to save to.
3. Set up the sound you want to save.
4. Press and hold the REVERB TYPE knob for two seconds.
5. You will soon see the PRESET LED blink rapidly. Continue to hold
down REVERB TYPE until the PRESET LED stops blinking.
6. The preset is now saved. You can release the REVERB TYPE knob.
RECALLING PRESETS USING THE REVERB TYPE KNOB
1. Use the SELECT button to select the desired reverb engine.
2. Turn the REVERB TYPE knob to the Reverb Type that you want to
recall.
3. Press and release the REVERB TYPE knob. The PRESET LED lights
indicating the preset has been loaded.
4. Once a preset is loaded and the PRESET LED is lit, changing to other
Reverb Types automatically recalls their presets. To disable presets,
see the section on the following page entitled UNLOADING PRESETS.
CHANGING PARAMETERS AFTER RECALLING PRESETS
Normally the PRESET LED lights solid after loading a preset. If you turn a
knob or press a non-FUNCTION button in the top row the PRESET LED
blinks to indicate that a preset is loaded but has been altered. Note: SEND
LVL and L/R SPLIT are global parameters and are NOT saved/recalled with
presets.
RELOADING ALTERED PRESETS
In the situation where a preset has been altered and therefore the PRESET
LED is blinking, press and release the REVERB TYPE knob to recall the
preset for the current Reverb Type.