User Manual

29
In PARALLEL, the two reverb engines individually process your instrument
audio, then their outputs are mixed:
The factory default configuration is PARALLEL. You can select which
configuration is active with the mini knobs after turning on the illuminated
FUNCTION button. On the Oceans 12, the teal-highlighted bottom row of
the Reverb Type table is labeled DUAL. When the FUNCTION button is lit,
the two mini knobs change their function to these teal-highlighted
alternate parameters, labeled SRS/PRL and A→B.
SRS/PRL: To arrange the dual reverbs in SERIES, turn this fully
counter-clockwise. To arrange them in PARALLEL, turn this knob fully
clockwise. The order of the reverbs in SERIES, and their mix balance in
PARALLEL, is determined by the other Mini Knob, explained below.
A→B: In SERIES, this knob selects the order of the two reverb
engines. If the knob is turned to the counter-clockwise half, then
Reverb A is first and its output goes to the input of Reverb B. If the
knob is turned to the clockwise half, then Reverb B is first and its output
goes to the input of Reverb A.
If the dual configuration is PARALLEL, this knob controls the mix
balance of the outputs of the two reverb engines. At noon, the mix is
100% Reverb A and 100% Reverb B. When this knob turns counter-
clockwise past noon, the Reverb B mix decreases towards 0% at
minimum. Likewise, turning clockwise past noon reduces the Reverb A
mix towards 0% at maximum.