User Manual

ECHO –

MODE: Cycles through the tempo subdivisions of the current echo

time: quarter-note (Mode 1), dotted-eighth-note (Mode 2), and

eighth-note (Mode 3).

FEEDBACK: Controls the number of repeats of the delayed signal. As

this knob is turned clockwise, the number of repeats increases.

DELAY: Controls the delay time of the echoes. Turn this knob

clockwise to increase the delay time. Delay time ranges from 5

milliseconds to 1 second.

TREM –

MODE: Cycles through three LFO wave shapes: triangle (Mode 1),

square (Mode 2), and sine (Mode 3).

RATE: Sets the rate of the amplitude LFO, from 1Hz at fully counter-

clockwise to 256Hz to fully clockwise.

DEPTH: Sets the depth of the amplitude LFO. Turn this knob

clockwise to increase the depth, and counter-clockwise to decrease it.

MOD –

MODE: Cycles through three different modulations. In Mode 1, a

chorus is applied to the reverb. In Mode 2, flanging is applied to

achieve a classic EHX flerb. In Mode 3, the chorus and flerb from your

settings in Mode 1 and Mode 2, respectively, are mixed together and

applied to the reverb.

RATE: Sets the rate of the modulation. In Mode 3, RATE sets the

blend amount between chorus (fully counter-clockwise) and flerb

(fully clockwise).

DEPTH: Sets the depth or intensity of the modulation. In Mode 3,

DEPTH doesn’t control anything.

DYNA –

MODE: The mode button cycles through three dynamic algorithms

with non-linear outputs.

- In Mode 1, a swell algorithm is selected that suppresses note

attacks and fades-in their reverb tails. TIME behaves normally and

controls the reverb decay.

- In Mode 2, a noise gate is selected that opens the reverb sound

for only louder notes. TIME controls the length of time the gate

stays open once it’s been triggered.