User Manual

11
ERASING SECONDARY KNOB SETTINGS
1. To erase the secondary knob settings of a particular reverb, press and
hold the MODE button. Then, while holding MODE, press and hold the
footswitch for 2 seconds. The LED will blink quickly indicating that the
secondary knob settings of the current reverb have been reset to the
default factory settings.
2. To erase the secondary knob settings of every reverb and restore
them all to factory defaults, first unplug the OCEANS 11 from power.
Press and hold the MODE button. Then, while holding MODE, plug
power back in to the OCEANS 11. The LED will blink quickly, indicating
that all secondary knob functions have been restored to the factory
default.
3. To erase the secondary knob settings of every reverb and reset both
the tap tempo and infinite reverb functionalities of the internal
footswitch to the factory default, first unplug the OCEANS 11 from
power. Press and hold both the MODE button and the footswitch.
Then, while holding both, plug power back in to the OCEANS 11. The
LED will cycle through red, orange and green to indicate that the
OCEANS 11 has been restored to factory default secondary knob
settings, infinite reverb settings, and tap tempo settings.
SECONDARY KNOB FUNCTIONS BY REVERB TYPE
See the chart on page 8 for a summary of these secondary knob functions.
HALL – The TIME knob controls Predelay time from a minimum of 0 sec
to a maximum of 1 sec. Factory default position is off, at the fully counter-
clockwise position. The TONE knob controls Predelay feedback. Factory
default position is zero, at the fully counter-clockwise position.
SPRING – The TIME knob selects spring length. The lowest third of the
knob’s travel selects 9.25-in. springs, the middle third selects 16.75-in.
springs, and the top third selects 24-in. springs. Factory default position
is 12 o’clock. The TONE knob controls a subtle amount of preamp drive
before the reverb circuit. Factory default position is 11 o’clock.
PLATE – The TIME knob controls Predelay time from a minimum of 0 sec
to a maximum of 1 sec. Factory default position is off, at the fully counter-
clockwise position. The TONE knob controls Predelay feedback. Factory
default position is zero, at the fully counter-clockwise position.
REVRS – The TIME knob controls Predelay time from a minimum of 0 sec
to a maximum of 1 sec. Factory default position is off, at the fully counter-