User Manual

NANO CLONE
Full Chorus
Congratulations on your purchase of the Electro Harmonix Nano Clone. The Nano
Clone is a compact battery operated Chorus device that features a RATE control
allowing you to change the speed of the Chorus.
To produce the Chorus effect, the Nano Clone bends the frequency slightly from the
input source and mixes this altered signal with some direct unaffected signal. The
combination produces a doubling effect.
- OPERATING INSTRUCTIONS -
Connect your instrument to the INPUT jack. Connect your amplifier to the AMP jack.
Please note that whenever a plug is inserted into the INPUT jack, the Nano Clone is
ON and it is draining current from the battery.
The RATE knob controls the speed of the chorus effect. Turning the RATE knob
clockwise increases the rate of the chorus.
The red LED will light up when the Nano Clone is in effect mode. When in True
Bypass mode, the LED will be off. Use the FOOTSWITCH to toggle between effect
and True Bypass mode.
- POWER -
Power from the internal 9-volt battery is activated by plugging into the INPUT jack.
The input cable should be removed when the unit is not in use to avoid running down
the battery. If a battery eliminator is used, the Nano Clone will be powered up as
long as a wall-wart is plugged into the wall.
The optional 9V power supply from Electro-Harmonix is US96DC-200BI (same as used
by Boss ™ & Ibanez™) 9.6 volts/DC 200ma. The barrel connector on the front of the
Nano Clone is for the 9-volt battery eliminator capable of delivering 100 mA of
current. The inner ring of the 9-volt battery eliminator must be negative, the outer
ring positive. The unit’s battery may be left in or taken out when the eliminator is in
use.
PLEASE NOTE: If the Nano Clone is connected to other effects pedals it will not
work with the same battery eliminator that is daisy chained to the other pedals. The

Summary of content (2 pages)