User Manual

Congratulations on your purchase of the Stereo Pulsar, a variable

shape tremolo and panner pedal.

Connected as a mono pedal, the Stereo Pulsar is exactly the same

as the Electro-Harmonix Pulsar that we currently manufactur: a

tremolo pedal that allows significant control over the shape of

modulating waveform. Hook up the Stereo Pulsar in stereo (each

output to a separate amp/mixer channel) and you have a panner

pedal that will send your instrument back and forth between two

amps with the same control over waveform shape. So while one

amp is fading up in volume, the other will be fading down in volume

or even more dramatic: while one amp is on, the other is off.

— CONTROLS —

SHAPE Switch – Selects between Triangle Wave and Square Wave Modes.

SHAPE Knob – Changes the shape of the waveform that modulates the Tremolo.

Triangle Wave Mode – In this mode the LFO creates a Triangle Wave

oscillation, resulting in a smooth modulation. As the SHAPE knob is turned

from the Counter-Clockwise (minimum) position to the Center (middle)

position, the waveform starts as a rising Sawtooth changing into a Triangle.

From the Center position to the Clockwise (maximum) position, the wave

changes from a Triangle to a falling Sawtooth.

PAGE 1
Congratulations on your purchase of the Stereo Pulsar, a variable shape tremolo and panner pedal. Connected as a mono pedal, the Stereo Pulsar is exactly the same as the Electro-Harmonix Pulsar that we currently manufactur: a tremolo pedal that allows significant control over the shape of modulating waveform.
PAGE 2
Square Wave Mode – In this mode, the LFO creates a Square Wave, resulting in a sharp, on/off modulation. As the SHAPE knob is turned from the Counter-Clockwise (minimum) position to the Center (middle) position, the wave starts as a Small Pulse Width Wave changing into a Square Wave. From the Center position to the Clockwise (maximum) position, the wave changes from a Square Wave to a Large Pulse Width Wave. DEPTH Knob – Adjusts the amount of Tremolo that will be applied to your signal.