User Manual

R EAR P ANEL
AC Voltage Selector Switch – Move this switch to the correct voltage setting for
your region or the voltage supplying power to your rig. Here are some typical
settings based on region:
• 230V: EUROPE / UK / AUSTRALIA / NEW ZEALAND
• 115V: USA / CANADA or JAPAN (for units marked for Japan)
WARNING: Setting the AC Voltage Selector switch to the wrong setting for your
region could result in damage to the MOP-D10 or an inability for the MOP-D10 to
supply the correct voltage and current to your pedals. Ensure the Voltage
Selector is in the correct position before applying power.
IEC Power Connector – Attach the female end of the supplied AC power cable to
this connector. Plug the other end of the AC cable into a wall outlet.
P EDALBOARD M OUNTING
The MOP-D10 can be mounted to the underside of most medium and large sized
pedalboards. Supplied with the MOP-D10 are four pedalboard mounting brackets
and four #6 sheet metal mounting (B) screws.
A Screws: Please note: the four A screws are installed into the sides of the MOP-
D10 at the factory. Remove these screws, two at a time, then reinstall while
attaching the brackets.
B Screws: Pilot holes: you may need to drill pilot holes in the pedalboard for
each B screw. We recommend a drill bit size ranging from 1/16” to 3/32”.
B
A
A
4 x Screw A –
installed in
MOP-D10 at
factory
4 x Screw B –
found in MOP-
D10 carton
A
B
B
B