User Manual

GETTING STARTED & INITIAL USE
Before powering up your MOP-D10 please ensure the AC Voltage switch
on the rear panel is set to the correct voltage for your region and the AC
voltage powering the MOP-D10.
IN THE BOX:
1 x MOP-D10 Isolated Multi-Output Power Supply
10 x DC cables with 5.5 x 2.1 (mm) plugs
1 x AC power cord
4 x Pedalboard mounting brackets
4 x Pedalboard mounting screws: Screw B
Before connecting the AC power cord—supplied with your MOP-D10—make all
cable connections from the MOP-D10 to the devices it will power.
Flip the MOP-D10’s front panel power switch to the ON position. The LED on the
front panel lights up. Power will now be supplied to all external devices connected
to the MOP-D10.
FRONT PANEL
Power Switch – Flip to the ON position to power up the MOP-D10. Setting the
power switch to the OFF-position cuts power to all ten output power connectors.
LED – The red LED lights when the unit is powered up.
9VDC/100mA – These four center-negative power connectors, located closest to
the power switch, provide up to 100mA at each output, at a voltage of 9VDC.
9VDC/250mA – These middle two center-negative power connectors provide up
to 250mA at each output, at a voltage of 9VDC.
9VDC/300mA – These middle two center-negative power connectors provide up
to 300mA at each output, at a voltage of 9VDC.
9VDC/400mA – These two center-negative power connectors, located near the
LED, provide up to 400mA at each output, at a voltage of 9VDC.
Please Note:
All output power jacks are isolated from each other.
Each output is center-negative.
The dimensions of each output connector are 5.5 x 2.1 (mm).
The MOP-D10 is supplied with ten DC power cables. Connect the output
power connectors on the front panel to the power connectors on your
pedals or devices.