User Manual

ManualsBrandsElectro Harmonix ManualsChorus - FlangerDeluxe Memory Man with Tap Tempo Ultimate Analog - DELAY CHORUS AND ANALOG VIBRATO WITH TAP TEMPO

TAP DIVIDE Button and LEDs – This button cycles through the six possible

settings for TAP DIVIDE. Each setting, except when all LEDS are off, will divide

the tap tempo to create shorter delay times in sync with your original tempo. It

works like so: The DMMTT always assumes that the musician taps in a quarter

note. That quarter note can then be divided down to five other types of notes:

dotted eighth note, quarter note triplet, eighth note, eighth note triplet and

sixteenth note. The sixth mode is quarter note or OFF, where the tap tempo is

not divided down and the delay time is set to your actual tap time. No LEDs are

lit when Tap Divide is set to quarter note/OFF. Below is a chart displaying the six

modes, their divide ratios and an example of the delay time for each mode:

TAP DIVIDE

MODE

SYMBOL

DIVIDE

RATIO

DELAY TIME (for a 600 mS

TAP)

Quarter Note / OFF

1 / 1

600 mS

Dotted 8th Note

3 / 4

450 mS

Quarter Note Triplet

2 / 3

400 mS

8th Note

1 / 2

300 mS

8th Note Triplet

1 / 3

200 mS

16th Note

1 / 4

150 mS

N.B. The TAP DIVIDE button has no effect on the delay time when the delay is

set by the DELAY knob. Cycling through the different TAP DIVIDE modes, when

the delay time was last set by the DELAY knob, will not change the delay time in

any way.

The TAP DIVIDE button setting is saved and recalled when power cycling.

TAP DIVIDE SEQUENCE MODE – The DMMTT contains a little easter egg

called Tap Divide Sequence mode. In this mode, the DMMTT will automatically

cycle through the six tap divide modes at a rate set by the RATE knob. To use

this mode, do the following:

1. Tap in a delay time. Tap Divide Sequence mode will not work if the

delay time is set by the DELAY knob.

2. Press and hold the TAP DIVIDE button for 2 seconds. After 2

seconds, all of the TAP DIVIDE LEDs will light up briefly, now you

are in sequencer mode. You can release the button.

3. Turn the RATE knob to change the speed of the sequence. You

should see the tap divide LEDs light up in a sequential fashion.

4. You can tap in new delay times to change the delay time range.

5. To exit Tap Divide Sequence mode: hold down the TAP DIVIDE

button for another 2 seconds. All 5 LEDs will light briefly to indicate

you have exited sequence mode. You could also simply turn the

DELAY knob.