User Manual

11
MONO/L and R OUTPUT Jacks
The Cathedral has true stereo output. The output jacks are labeled: MONO/L and R. If
using the Cathedral as a mono effect we suggest you use the MONO/L input and output.
The Cathedral can also be used with Mono in and Stereo out. Plug your input into the
MONO/L jack and then connect the MONO/L and R Outputs to two separate amps or inputs
on a mixing board.
When you connect the Cathedral in a Mono to Stereo configuration in ECHO mode, the
delays will bounce or ping-pong between the two outputs. The first repeat will go out the
MONO/L Output; the second repeat will go out the R Output, the third repeat out the
MONO/L Output and so on. When you connect a plug to the R Input, the Cathedral will
stop the ping-pong effect: whatever goes into the Right Input will go out the Right Output;
whatever goes in the Left Input will go out the Left Output.
9V Power Jack
Plug the output of the Cathedral’s supplied AC Adapter into the 9V power jack located at
the top of the Cathedral. The Cathedral requires 9 - 9.6VDC at 200mA with a center
negative plug. The Cathedral accepts Boss style AC Adapters.
Technical Specifications
Sample Rate = 46.88 kHz
A/D and D/A Conversion Bit Resolution = 24 bits
Processed Audio Bit Resolution = 32 bits
- Presets -
PRESETS
The Cathedral can save one preset for each of its 8 modes. Each saved preset will pertain
directly to the mode you have saved it in. For example the sound you save in Grail Spring
mode will always be a Grail Spring setting. Once a preset is saved, the Cathedral will
remember the preset after power has been disconnected.
Saving a preset will save the setting of all 5 of black knobs. It will also save a tapped in
delay time if that is the current delay time at the moment of saving the preset.
PRESET SAVE PROCEDURE:
1. To save the sound you are currently hearing, press and hold down the MODE
knob.