User Manual

Post-EQ
Dry-EQ
JACKS, XLR CONTROLS, POWER
INPUT Jack – Plug your instrument or the output of another effects pedal
into this ¼” jack. The input impedance is 2.2M.
DRY OUTPUT Jack – Use this ¼” jack to output a dry, unaffected version
of your bass signal.
OUTPUT Jack – Use this ¼” jack to output the signal, dry or affected based
on the bypass status. Plug this jack into an amp, another effects pedal, or
plug headphones into this jack. The output impedance is 220.
XLR Jack – Use this to output a balanced signal.
XLR VOL Knob – Use this to set the volume of the XLR output.
XLR Bypass Button – Push in to have the XLR output the signal based on
the bypass state of the pedal. Leave out to output the dry signal regardless
of the bypass state of the pedal.
Ground Lift Button – Push in to keep ground connected to pin 1 of the
XLR jack. Leave out to disconnect pin 1 from ground.
9V Power Jack – Plug the output of the factory-supplied EHX9.6DC 200mA
AC adapter into the 9V power jack located at the top of the Battalion. The
Battalion draws 100mA at 9VDC with a center negative plug. The
Battalion accepts Boss
®
and Ibanez
®
style AC Adapters capable of delivering
at least 200mA.