User Manual

PRESETS
When the LED on the Bass Mono Synth (BMS) is green, you are in live WYSIWYG
mode, meaning that the current knob and expression pedal settings represent the
sound that is produced. You can also save and recall one preset for each of the
eleven synth types. All four knobs in the top row are saved along with the setting
of the expression pedal—when an expression pedal is attached at the time of
saving the preset. The LED lights red when Preset mode is active.
RECALLING A PRESET
1. Assuming the Status LED is green at the moment, turn the TYPE knob
to the synth type that you want to recall. If the Status LED is currently
red skip to step 3.
2. Press and release the PRESET footswitch. The preset for the current
synth type will be recalled and the Status LED lights red.
3. At this time you may turn the TYPE knob to load the preset for each
synth type.
4. Press and release the PRESET footswitch to return to WYSIWYG mode.
SAVING A PRESET
1. A preset may be saved while either in WYSIWYG or Preset mode.
2. Press and hold the PRESET footswitch. After holding for about 2
seconds you will see the LED blink red at a fast rate.
3. Once the LED blinks red you may release the PRESET footswitch, the
preset is now saved.
4. If an expression pedal is attached we recommend you don’t move it
while saving a preset.
EDITING A PRESET
1. After recalling a preset, the LED lights solid red.
2. If you move any of the four knobs in the top row of knobs, the LED
blinks red to indicate that a preset is loaded but has been changed in
some way.
3. The LED does not blink if the expression pedal is moved after loading a
preset.
4. If you press and release the PRESET footswitch, while the LED is
blinking red, it will reload the preset from memory. After reloading, the
LED lights solid red again.
5. If you press and hold the PRESET footswitch while the LED is blinking
red, your newly edit preset will be saved to memory. Press and hold the
PRESET footswitch until you see the LED blink at a fast pace.
EXITING PRESET MODE
To exit Preset mode and return to WYSIWYG mode, simply press and release the
PRESET footswitch. The LED will turn green. If the preset had been edited and
you see the LED blinking red, press and release the PRESET footswitch twice to
return to WYSIWG mode.