Manualshelf

User Manual

ManualsBrandsElectro Harmonix ManualsGuitar EffectsREVERSE BELT SIMULATION EFFECT WITH PEDAL FUZZ
11121314151617181920
16
3. While the BYPASS footswitch is held, press and release the PRESET 2
button. After releasing this button, release the BYPASS footswitch.
4. The PRESET 2 and Status LEDs will blink at different rates indicating
that you are in Harmonix Blend mode.
5. Turn the BLEND knob to adjust the fuzz/dry mix.
6. You may create an expression setting where the expression pedal
sweeps Harmonix Blend among other parameters at this point.
7. Once you are finished setting Harmonix Blend, press the PRESET 2
button to exit the mode -or- if you like, save the new setting to a
Preset, by pressing and holding down a preset button until they stop
blinking.
8. After exiting, the BLEND knob resumes adjusting master blend
wet/dry mix.
RETURN BLEND MODE
A second optional Blend mode is Return Blend. It allows you to control the
mix between the signal at the RETURN jack (CCW on BLEND) and the
output of the volume envelopes (CW on BLEND). Master Blend then
follows Return Blend.
Return Blend mode is a temporary mode, allowing you to use the BLEND
knob to set Return Blend while this mode is active. Here’s how to enter,
use and exit Return Blend mode:
1. Ensure a plug is inserted into the RETURN jack.
2. Press and hold the BYPASS footswitch.
3. While the BYPASS footswitch is held, press and release the PRESET 3
button. After releasing this button, release the BYPASS footswitch.
4. The PRESET 3 and Status LEDs will blink at different rates indicating
that you are in Return Blend mode.
5. Turn the BLEND knob to adjust the return/effect mix.
6. You may create an expression setting where the expression pedal
sweeps Return Blend among other parameters.
7. Once you are finished setting Return Blend, press the PRESET 3 button
to exit the mode -or- if you want to save the new setting to a Preset,
save to a preset button.
8. After exiting, the BLEND knob resumes adjusting master blend
wet/dry mix.
RETURN BYPASS MODE
1. Press and hold POLY and PRESET 3.
2. Press and release the BYPASS footswitch. Release all buttons.
3. The Status LED blinks rapidly to indicate Return Bypass is enabled.
4. Perform steps 1 and 2 to disable Return Bypass, Status blinks slowly.