User Manual

14
Return Bypass is active, while in Bypass, the Harmonix effect is not
output on the SEND jack even if Harmonix is active.
3. If you want to use the Attack Decay solely as a distortion effect, you
can use the SEND jack as the main output jack. The HARMONIX
footswitch will turn the distortion on and off. The H. VOL knob will act
as a master volume control. In this setup, the VOL, SENS, ATTACK,
and DECAY knobs have no function.
4. In Mono mode, the Attack Decay can be set up so the instrument at
the INPUT jack triggers the volume envelope for a second instrument
at the RETURN jack. To achieve this, plug the instrument you want to
effect into the RETURN jack and plug the instrument that will trigger
the Attack Decay’s envelope into the INPUT jack. When a pluck is
detected at the INPUT jack, the Attack Decay runs its volume
envelopes on the signal present at the RETURN jack.
RESTORING FACTORY SETTINGS
To restore the Attack Decay to its factory default settings, press and hold
the BYPASS footswitch while plugging power into the Attack Decay.
1. Unplug the Attack Decay from power.
2. Press and hold the BYPASS footswitch.
3. Apply power to the Attack Decay.
4. Continue holding the BYPASS footswitch until one or more of the
PRESET LEDs start flashing.
5. Once a PRESET LED flashes you may release the BYPASS footswitch.
The following factory default settings will be restored:
 All presets are erased and restored to their factory default settings.
 The custom expression pedal setting is erased and restored to the
factory default: expression controls the output volume.
 Continuous Envelopes (tremolo) are set to off.
 Mono Mode’s envelope shapes are set to parabolic.
 External and Manual Clock Triggering are turned off.
 The Attack Decay’s internal compressor is set to on for both Poly and
Mono modes.
 Harmonix is placed before the SEND jack in the FX loop.
 Return Bypass is disabled.
 Harmonix and Return Blend are both set respectively to 100% fuzz
and return.