User Manual

you increase its value. Turning the MODE knob clockwise increases the Glide value.

Please

Note:

high values of GLIDE with fast tempos will reduce the sequencer’s output amplitude.

DIR (Direction):

Selects between four settings for the sequencer’s playback direction.

Turning the MODE knob clockwise presents the choices in the following order:

F (Forward):

The sequence counts up from Step 1 to the maximum

step set by the Sequence Length (SL) parameter, and then jumps back

to Step 1 again.

r (Reverse):

The sequence counts down from the maximum step set by

the SL parameter to Step 1, then jumps back to the maximum step.

b (Bounce):

Combines the Forward and Reverse Direction modes. The

sequence starts at Step 1, counts up to the maximum step, and then

counts back down to the Step 1.

R (Random):

The sequence randomly selects each step between Step 1

and the maximum step value set by SL. Since each step is random, it is

possible that the same step could be repeated two or more times in a

row.

SL (Sequence Length):

Sets the maximum step of the sequence. The available range is

1 Step to 8 Steps. Each sequence always includes Step 1, the number you set SL to

indicates the maximum step of the sequence. For example, if you want a 6 step sequence

set SL to 6. If you want the full sequence range, set SL to 8. As you turn the MODE knob

clockwise SL’s value increases.

PRESETS AND THE MODE KNOB

Push and hold the MODE knob for more than 2 seconds to enter PRESETS mode. Once in

PRESETS mode push and hold MODE for more than 1.5 seconds to save a preset.

ENTER PRESETS MODE:

To enter PRESETS mode, push and hold the MODE knob for

more than 2 seconds. After 2 seconds, the digit display will flash a P for about 1.5 seconds;

this indicates that you are now in PRESETS mode. Additionally, when in PRESETS mode, all

three MODE LEDs are off.

CHOOSING & LOADING A PRESET:

Once in PRESETS mode, turn the MODE knob to go

up or down through the presets. As you turn the MODE knob clockwise, the preset number

increases. When you arrive at the preset you want to load, push and release the MODE

knob to load the preset. Upon loading a preset, the decimal in the digit display lights solid.

To unload a preset go back to the preset number that is currently loaded then press and

release the MODE knob.

If you turn the MODE knob while a preset is loaded and you are in PRESETS mode, the

digit display will blink the preset number. A blinking number in the display indicates that it