User Manual

– REFERENCE GUIDE –

STOP FOOTSWITCH

1. To use the second footswitch to stop loop playback, press and hold the

MODE button for two seconds. A dot will appear on the digit display next to

the STOP label.

2. To immediately stop loop playback, press the STOP footswitch once. The

loop is automatically reset to the beginning.

3. To pause loop playback, double-tap the STOP footswitch. Playback will halt

at the current position, and resume at the same place if the LOOP footswitch

is pressed again.

Note: Fadeout must be set to ‘0’ (disabled) in order to pause a loop.

4. When STOP mode is active, the REVERSE and ½ SPEED effects are only

accessible through the REVERSE and ½ SPEED buttons.

FX FOOTSWITCH

1. To use the STOP/FX footswitch to toggle loop effects, press and hold the

MODE button for 2-seconds. The dot on the digit display next to the STOP

label will disappear, indicating that FX mode is active.

2. When FX mode is active, use the REVERSE and ½ SPEED buttons to

enable

each effect. The FX footswitch toggles the selected effect(s) on or off.

3. The FX LED above the footswitch indicates whether the FX mode is active;

when the FX LED is lit, the FX are activated.

UNDO-REDO FUNCTION

1. To undo an overdub (remove the last take) during Loop playback; press and

hold the LOOP footswitch for 2-seconds. The PLAY LED will blink twice and

the previous overdub will be removed.

2. To redo an overdub (restore the last take) during Loop playback: press and

hold the LOOP footswitch for two seconds. The PLAY LED will blink twice

and the previous overdub will be restored.

3. The Undo-Redo function can only be initiated while a loop is playing back.

Undo-Redo cannot be performed during overdub, record or stop modes.

4. Note: once UNDO-REDO is enabled, this function is available until the loop

is erased. The undo-redo layer is preserved regardless of bank changes and

power cycles.

5. Shortcut: pressing and holding the LOOP footswitch when stopping an

overdub will cause an undo. This action gives you a convenient way to

quickly undo overdubbing mistakes.