User Manual

10
LOOPING ORDER
Establish a Workflow – Think about the looping order that suits your
workflow. Or, simply experiment with the two options for looping order that are
set in the following manner:
To initialize REC/PLAY/DUB mode:
1. Unplug the power jack.
2. Simultaneously plug in the power jack while holding down the REVERSE
button for three seconds.
3. The digit display will show the sequence “o – o – 1 – 1”
4. The power on cycle will continue as usual.
To initialize REC/DUB/PLAY mode:
1. Unplug the power jack.
2. Simultaneously plug in the power jack while holding down the ½ SPEED
button for three seconds.
3. The digit display will show the sequence “o – o – 2 – 2”
4. The power on cycle will continue as usual.
FACTORY RESTORE
To initialize a Factory Restore:
1. Unplug the power jack.
2. Simultaneously plug in the power jack while holding down the LOOP
footswitch for three seconds until the REC, PLAY, and MEM LEDs begin to
flash together.
3. Once all three LEDs start blinking you can release the footswitch at any
time. All three LEDs will continue to flash for about one second until the
Factory Restore process is complete.
4. After the process is complete, Loop-select mode is entered with LOOP 0 as
the default bank, fadeout disabled, all effects off, and STOP mode enabled.
5. Note: All Loop audio is erased during Factory Restore, and the process
cannot be undone.
- CHANGING THE BATTERY -
To change your 9V battery, remove the four screws on the bottom of the 720.
Take off the bottom plate and change the battery. Do not touch the circuit board
while the bottom plate is off or you risk damaging a component.
Typical current draw from the Stereo Looper 720 is 60mA, which gives about 8
hours of operation on a single, high-quality alkaline battery.