User Manual

CHILD LOCK

Hold the LOCK button for 5 seconds to activate the child lock. The LED

indicator will illuminate to show the child lock is activated. To turn it off hold the

LOCK button again for 5 seconds.

WIFI

Hold the WIFI button for 6 seconds to reset the WIFI module ready for

connection, or to change the connection method between AP (Access point)

and CF (Quick Connection) modes. This also resets the WIFI module.

OK INDICATOR

When lit, shows that the desired humidity set has been reached, and the

compressor is in standby mode

DEFROST INDICATOR

The appliance will defrost automatically when the coil sensor detects that the

internal temperature is too low. During defrosting the indicator will light up.

Once the defrost cycle has finished, the appliance will return to the mode that

was previously operating.

TANK FULL

When the water tank is full, the TANK FULL indicator light will flash, and the

unit will stop operating. Once emptied and replaced, the appliance will resume

operation.

DISPLAY

As default, the unit will display the current humidity of the room. The unit is

also able to display the current room temperature. Press the UP and DOWN

buttons at the same time to change between the units shown.

If the UP or DOWN button are pressed, the display will show the desired

humidity set on the dehumidifier.

While the timer is set, the unit will display the duration of the timer.