User Manual

Page 9 of 15
OPERATION AND SETTINGS
CONTROL PANEL & FUNCTION
POWER BUTTON
Press to turn unit “ON” or “OFF”
MODE
Pressing this button will select between the Cooling , Heating , Auto, Fan and
Dehumidify modes.
COOLING MODE: Cold air will be expelled through the top of the unit and hot air will
be expelled through the vent hose.
HEATING MODE: Hot air will be expelled through the top of the unit and cold air will be
expelled through the vent hose. Continuous drainage should be set up for the moisture
collected.
DEHUMIDIFY MODE: The unit should be set up without a vent hose, moisture is
extracted from the air that passes through the unit. Continuous drainage should be set
up for the moisture collected.
FAN MODE: No cooling effect, circulates air within the room, vent pipe not required.
AUTO MODE: The unit will change between Heating, cooling and fan modes depending
on the desired temperature set.
TEMPERATURE UP & DOWN
During cooling and heating modes – These buttons raise or lower the temperature by 1
o
C
for each press. The minimum temperature is 16
o
C and max. 31
o
C.
FAN SPEED
Press to select either LOW, MEDIUM or HIGH fan speed.
NOTE: In dehumidifying mode, this button is invalid as the unit is designed to run at low
speed in dehumidifying mode.