User Manual

WATER DRAINAGE

The water tank has a capacity of approximately 2 litres. When

the water tank is full, the unit will switch off automatically and

the Indicator LED around the power button will illuminate

orange.

To empty the water tank:

• Turn off the dehumidifier by pressing the power button

so that the indicator LED goes out.

• Remove the water tank from the unit, by holding the

handle on the tank and sliding it out of the rear of the

unit.

• Unclip the lid from the top of the water tank

• Empty the water in to a toilet or sink.

• When the water tank has been emptied,

reattach the lid and insert the tank back into

the unit.

To continue dehumidifying, press the Power button so

that the LED indicator is green, and the dehumidifier

will start to operate

CARE AND MAINTENANCE

Always turn off the unit and unplug it from the mains before cleaning or performing any maintenance.

When it is not in use for long periods, it is advisable to unplug the appliance. Do not use chemical solvents

(such as benzene, alcohol or gasoline) as they may cause irreversible damage to the unit.

CLEANING THE CASING

Use a piece of soft cloth to clean the surface of the product or use a brush to wipe dust off the air inlet and

the air outlets.

FILTER CLEANING

This dehumidifier contains a mesh dust filter behind the air inlet. This

should be regularly cleaned by sliding it out of the base of the dehumidifier.

Use a vacuum cleaner or soft brush to remove the accumulated dust. For

a deeper clean the filter can be washed in a solution of water and a mild

detergent. Do not use bleach or abrasives. Allow the filter to fully dry

before inserting back into the dehumidifier.

Note: Never use the unit without the antibacterial mesh dust filter.