User Manual

MAINTENANCE

FILTERS

Ensure the power is turned off to the unit before attempting to service the filters.

OPENING THE FRONT PANEL: At the recesses,

pull the front part up with both hands. The front

panel will stay horizontal (at around 90°).

CLOSING THE FRONT PANEL: Press the front

part down at the sides and in the middle. Make sure

it is properly clicks into place.

REMOVING AND REPLACING THE FILTERS

1. Hold the front panel open (or put it in horizontal

position) and remove the filter(s).

2. Use a vacuum cleaner to remove dirt. If the dust

filter is very dirty, it may be washed in lukewarm

water with a very small amount of neutral detergent.

Rinse well and allow to dry completely (not in direct

sunlight or near a source of heat).

3. Keep the front panel open and

reinstall the filter(s). Press the

panel shut; a click indicates it is

closed properly.

4. Restore the power from the

consumer unit and turn the air

conditioner on.

INDOOR UNIT: While the unit is disconnected from power dust regularly with a dry cloth or

slightly damp paper towel. Never use chemicals or solvents. Never spray a liquid in or over the

appliance.

OUTDOOR UNIT: While the unit is disconnected from power. Remove dirt and keep the air

intake and exhaust openings free of debris, etc. Cleaning with chemicals may cause damage.