USER MANUAL TABLE TOP HEATER EQODETT Thank you for choosing electriQ Please read the manual before using this heater and keep it safe for future reference. Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 OPERATION 5 CLEANING AND MAINTENANCE 6 TECHNICAL SPECIFICATIONS 6 TROUBLESHOOTING 6 SUPPORT 7 2
SAFETY INSTRUCTIONS IMPORTANT • Carefully read the instructions before operating this unit. • Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. • Installation must be in accordance with the regulations of the country where the unit is used. • If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified by a qualified electrician. • This heater has been tested and is safe to use.
• Do not attempt to repair, disassemble or modify the appliance. This unit contains no user-serviceable parts. • Always unplug or disconnect the appliance from the mains power supply when not in use, or when moving or cleaning it. Do not pull the cord to unplug the heater. • Keep the heater clean. Do not allow any object to enter the ventilation or exhaust opening as this may cause electric shock, fire, or damage to the heater. • Do not use the appliance for anything other than its intended use.
OPERATION The main control dial can be turned anti clockwise to select the power level without the oscillating function. LOW HIGH 600W 1200 W To use the oscillation function turn the main control dial clockwise to: 600W with oscillation 1200 W with oscillation In addition to turning the oscillating function on or off, the top dial can be used to select the extent of the oscillation: 120° The unit will twist in a 120 degree arc, heating the area in front of it.
CLEANING AND MAINTENANCE ATTENTION: Please turn off the unit and unplug from the mains and allow to fully cool before cleaning or performing any maintenance. CLEANING THE SURFACE • Clean the heater with a duster or a soft wet cloth. • Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage. Make sure no water enters the control panel or gaps in the casing. • Do not run the unit until completely dry.
electriQ UK SUPPORT www.electriQ.co.uk/support Please, for your own convenience, make these simple checks before calling the service line. If the unit still fails to operate call: 0330 390 3061 or complete the online form 1. Is the unit plugged into the mains? 2. Is the fuse OK? 3. Switch the unit off and wait three minutes to see if the issue is resolved. Restart the unit. Office hours: 9AM - 5PM Monday to Friday www.electriQ.co.
Model Identifier: EQODETT Item Symbol Value Unit Heat Output Item Unit Type of heat input, for electric storage local space heaters only (select one) Nominal heat output Pnom 1.2 kW manual heat charge control, with integrated thermostat N/A Minimal heat output Pmin 0.6 kW manual heat charge control with room and/or outdoor temperature feedback N/A Maximum continuous heat output Pmax 1.
