User Manual

8
5. On the top of the hood unit, where the air outlet vent is located, the 2 x air
flaps should be carefully installed, bending very slightly so the lugs at each
end fit into the holes This enables the flaps to pivot upwards when the unit
is in operation, opening up the outlet fully for the air to pass through.
Please note: The small spindles/lugs at each end of each flap fit into the holes
on the housing, not the grooves above them:
6. Lift the main body of the cooker hood
onto the angle bar and then fix it into
position using the 16 x M5 screws.
IMPORTANT:
This stage of the installation process
MUST be completed by two people, as one
person must support the weight of the hood
until all 16 of the M4 screws have been
securely tightened.
8. The unit should then be connected to a suitable power source, either by
using the supplied plug, or hardwiring the unit into a spur. Please note if hard
wiring the unit, a suitable switch should be fitted in a conveniently accessible
position.
9. Remove the hanging hook and
then slide the lower chimney section
downwards, until it rests against the
main body of the cooker hood.