User Manual

STANDARD HEIGHT INSTALLATION

Do not connect the hood to the mains supply before installing it.

1. Position the hanging plate on the ceiling

and then mark the position of the screw

holes with a pencil.

Securely fix the hanging plate to the ceiling,

using the 11 x ST4 (30 mm) screws.

Please ensure that the bracket is fixed in a

way it would support the weight of the hood.

Depending on the construction of the ceiling, alternative fixings may be

required. 6 x expansion bolts are also provided to allow fitting to concrete.

2. Fix the angle bars to the hanging plate, using

the 8 x M5 screws.

3. Extend the angle bars to the required height

and then fix them in position using the 16 x M5

screws. The angle bars must have an overlap

of at least 100mm.

4. At this point, if the unit is to be externally vented

connect the ducting hose to the hanging plate. Then fix

the upper chimney section to the hanging plate, using

the 4 x self tapping screws (4mm x 6mm).

Slide the lower chimney section onto the angle bars and

raise it until it sits just below the upper chimney section.

Use the hanging hook to temporarily keep the lower

chimney section in this position, to make sure that it

does not drop down whilst fixing the main body of the

hood to the angle bars.