User Manual

MAINTENANCE

Before cleaning, switch the unit off and pull out the plug, or switch off at the

relevant mains switch. If the unit has been hard-wired in. Make sure the unit has

no power being fed to it.

REGULAR CLEANING

Use a soft cloth moistened with hand-warm mildly soapy water or household

cleaning detergent. Never use metal pads, chemicals, abrasive material or a

stiff brush to clean the unit.

Note! Do not use a steam-cleaner to clean the hood; electrical components

could be damaged or short-circuit as a result.

MONTHLY CLEANING OF ALUMINIUM GREASE FILTER

ESSENTIAL NOTE: Clean the filter every month; an excessive build-up of

grease can become a fire hazard. The filter collects grease, smoke and dust,

so the filter directly affects the efficiency of the cooker hood. If it’s not cleaned,

the grease residue (potentially flammable) will saturate on the filter.

Remove the filter as shown in the Installation section. Clean it with a soft nylon

brush in a mild solution of warm water and a small amount of washing up

liquid. Washing up liquid alone should not be used. After cleaning, allow the

filter to drain and then dry thoroughly.

The grease filter may also be dishwasher cleaned; using a 60°C program, with

the filter upright (short sides upright) in the lower basket. Please be aware

some dishwasher cleaning agents can permanently discolour the filter, though

this will not affects its performance.

Replacement grease filters are available from the same stockist from which

you purchased the hood: eiQTMGREASE2

REPLACEMENT OF ACTIVE CARBON FILTER

These are only required in units that have been installed in recirculation mode

This filter traps odours and must be replaced ideally every 3-6 months

depending on how frequently the cooker hood has been used. They are not

washable or reusable.

Reference: eIQTMCARBONCURV - Carbon Filter Pack