User Manual

10
5. Securely fix the angle bars to the
hood using 16 x M5(10mm) screws, and
connect the outlet with the exhaust pipe
( If venting externally)
6. Slide the inner chimney and outer
chimney onto the angle bars
7. If externally venting, connect the
exhaust pipe to the hanging plate.
The angle bar should then be fixed to the
hanging plate using the 8 x M5 screws.
IMPORTANT:
This stage of the installation process
MUST be completed by two people, as
one person must support the weight of
the hood until all the screws have been
securely tightened.
8. The unit should then be connected to
a suitable power source, either by using
the supplied plug, or hardwiring the unit
into a spur. Please note if hard wiring
the unit, a suitable switch should be
fitted in a conveniently accessible
position.
9. Slide the inner chimney up, and use 4
x self tapping screws to connect the
inner chimney with the hanging plate,
then the installation is complete