User Manual

ALTERNATIVE INSTALLATION FOR MINIMUM CHIMNEY

LENGTH

Do not connect the hood to the mains supply before installing it.

1. Position the hanging plate on the ceiling

and then mark the position of the screw

holes with a pencil.

Securely fix the hanging plate to the ceiling,

using the 11 x ST4 (30 mm) screws.

Please ensure that the bracket is fixed in a

way it would support the weight of the

hood. Depending on the construction of

the ceiling, alternative fixings may be

required. 6 x expansion bolts are also provided to allow fitting to concrete.

2. Calculate the length of the angle bars

according to the overall height of the hood

required. Extend the angle bars to the

required height and then fix them in

position using the 16 x M5 screws. The

angle bars must have an overlap of at least

100mm.

4. On the top of the hood unit, where the air outlet vent is located, the 2 x air

flaps should be carefully installed, bending very slightly so the lugs at each end

fit into the holes This enables the flaps to pivot upwards when the unit is in

operation, opening up the outlet fully for the air to pass through.

Please note: The small

spindles/lugs at each end of each

flap fit into the holes on the

housing, not the grooves above

them: