User Manual

13
MAINTENANCE
Before cleaning, switch the unit off and pull out the plug, or switch off at the
relevant mains switch. If the unit has been hard-wired in. Make sure the unit has
no power being fed to it.
REGULAR CLEANING
Use a soft cloth moistened with hand-warm mildly soapy water or household
cleaning detergent. Never use metal pads, chemicals, abrasive material or a
stiff brush to clean the unit.
Note! Do not use a steam- cleaner to clean the hood; electrical components
could be damaged or short-circuit as a result.
CLEANING OF ALUMINIUM GREASE
ESSENTIAL NOTE: Clean the month; an excessive build-up of
grease can become a hazard. The collects grease, smoke and dust,
so the directly affects the the cooker hood. If it’s not cleaned,
the grease residue (potentially ) will saturate on the .
Remove the as shown in the Installation section. Clean it with a soft
nylon brush in a mild solution of warm water and a small amount of washing
up liquid. Washing up liquid alone should not be used. After cleaning, allow the
to drain and then dry thoroughly.
。
The grease may also be dishwasher cleaned; using a 60 C program, with
upright (short sides upright) in the lower basket. Please be aware
some dishwasher cleaning agents can permanently discolour the , though
this will not affects its performance.
Replacement grease available from the same stockist from which
you purchased the hood: eiQTMGREASE3
REPLACEMENT OF ACTIVE CARBON
These are only required in units that have been installed in recirculation mode
This ter traps odours and must be replaced ideally every 3- 6 months
depending on how frequently the cooker hood has been used. They are not
washable or reusable.
Reference: eIQTMCARBONCURV - Carbon Filter Pack