User Manual
11
CARBON (Available Separately)
Activated carbon can be used to trap odours, and must be used if the
unit is not vented externally. These are available from the same stockist the
hood was purchased from under reference: eIQTMCARBONCURV
CARBON
In order to install the activated
carbon , the aluminium
grease should be removed
. Press the lock and pull it
downward as below:
Put the activated carbon onto the end of the motor unit and turn it in
clockwise direction. Repeat the same on the other side (see diagram)
NOTE:
• Make sure the is securely locked. Otherwise, it could loosen and
cause damage to the unit.
• When the activated carbon are attached, the suction power will be
reduced.
• The charcoal ter cannot be washed or recycled. It should be changed at
three or six month intervals, depending on the amount of use the hood
receives. Replacements are available from the stockist you purchased the
hood from.