User Manual

10
Please note: The small
spindles/lugs at each end of
each holes on
the housing, not the grooves
above them.
4. Securely
using 16 x M5(10mm) screws, and
connect the outlet with the exhaust pipe (If
venting externally)
5. Slide the inner chimney and outer
chimney onto the angle bars.
7. If externally venting, connect the
exhaust pipe to the hanging plate.
The angle bar should then be to the
hanging plate using the 8 x M5 screws.
: This stage of the installation process MUST be completed by two
people, as one person must support the weight of the hood until all the screws
have been securely tightened.
8. The unit should then be connected to a
suitable power source, either by using the
supplied plug, or hardwiring the unit into a
spur. Please note if hardwiring the unit, a
suitable switch should be in a
conveniently accessible position.
9. Slide the inner chimney up, and use 4 x
self-tapping screws to connect the inner
chimney with the hanging plate, then the
installation is complete .