User Manual

9
FOR MINIMUM CHIMNEY
LENGTH
Do not connect the hood to the mains supply before installing it.
1. Position the hanging plate on the ceiling
and then mark the position of the screw
holes with a pencil.
Securely the hanging plate to the
ceiling, using x ST4 (30 mm)
screws.
Please ensure that the bracket is in a way it would support the weight of
the hood. Depending on the construction of the ceiling, alternative may
be required. 6 x expansion bolts are also provided to allow to concrete.
2. Calculate the length of the angle bars
according to the overall height of the hood
required. Extend the angle bars to the
requi in position
using the 16 x M5 screws. The angle bars
must have an overlap of at least 100mm.
3. On the top of the hood unit , where the air outlet vent is located, the 2 x
air should be carefully installed, bending very slightly so the lugs at
each end the holes This enables to pivot upwards when
the unit is in operation, opening up the outlet fully for the air to pass
through
.